The Design Intent of this series is to produce 33" Foamy "Block Built" Profile planes as close to scale as possible. Keeping Very Simple and Very Inexpensive allways in mind. Built around Grayson Hobbies Disposable Foamy power plant (CB2208-14) or similar set up. 3 servos. (I have no connection with GH, I just like the 19.95 price point) Attention to Scale detail is of primary concern, compromises made due to flat plate foam construction are kept minimal. I have intentionally left out "G" code for several reasons. I live in Ireland and all our stuff is metric and the powerplant you choose will most likely differ etc. Just seemed to me that each of you will end up with your own code. Lasty, no attempt was made as to "nesting" or laying out the parts the way you might cut them. Notes: In many respects this was the finest overall piston Fighter of WWII. It was faster, out climbed and carried more payload than the Mustang. Oh, it could land on a Carrier as well! Up to this point Planes in this Series I would consider Skill Lvl 1. This is a Skill Lvl 2 as it requires a separate construction of the wing components, building a Wing Jig, and forming a Wire Spar, not to mention the challenges of placing the Servo(s) for the Ailerons. I will reply to any and all questions, suggestions etc. All the best USXPAT [paypal]maxdeals@live.com[/paypal] Attached files 33 Corsair PB.skp (2.7 MB)Â