1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Looking for parts Phlatprinter 3 #41

Discussion in 'General Phlatprinter 3 Chat' started by Learjets, Mar 9, 2017.

  1. Learjets

    Learjets New Member

    Offline
    Messages:
    2
    Trophy Points:
    1
    Location:
    Lebanon, IN
    I was given kit #41, all unopened boxes. I am missing the small gear that goes on the X axis (roller stepper) stepper motor that drives the belt. Any idea of a P/N? or # of teeth, shaft size? and where I can order it!
     
  2. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    You should pm kram242 (the designer of the Phlatprinter).
    He should be able to give you the part#. He might even still have an extra.
     
  3. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    Learjets, if you are talking about the pulley that goes on the stepper motor, I took a look at mine and it looks like it's a 16 teeth pulley. They are very inexpensive. You may get one sent from China for less than $2.
     
  4. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    I believe it was mxl also not the typical g2 pulleys we normally see. The original pulley came from www.sdp-si.com
     
  5. Learjets

    Learjets New Member

    Offline
    Messages:
    2
    Trophy Points:
    1
    Location:
    Lebanon, IN
    TigerPilot - is the stepper gear on the gantry the same as the roller stepper stepper?
     
  6. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    I can not recall if i changed my pulleys on the z axis or not. The ones I have now are 15 tooth and the one on the x axis stepper is 16 tooth.

    Get yourself a 15 tooth and a 16 tooth and use the one that fits best with the closed loop belt.
     

Share This Page