Sign Up and take a look around. There are so many awesome new features.
have fun sharing our RC adventures!
I would like to know if I'm doing something wrong, because when I test me step motor the rpm is is almost nill. The setup is as follows: 4 x...
Got the usb board from Planet cnc and I want ot setup the following together I have the following: Stepper motor driver...
Ok d/l the new version of phlatscript/sketchUcam, installed ok but when I go to parameter the box appears with all the squares where you input...
My old computer died and now all I have is USB ports, also this put my phlats on hold... :( can't make any planes...... I wanted to know if it is...
Ok followed the tutorial sketchup to pdf using cutepdf. I have a problem where 3dmon says to select cutepdf as output he mentiones that the scale...
I installed the new phlatscript and now when I cut the tool gets packed with foam. my slots are supposed to be 3/16, but by the time its finished...
Ok i have a tail to cut but i don't want to make it in 2 piece. included is my pic, All I need to do is a one cut pass with tabs...anyu...
What would be a good setting for these motor pk266-01A Like what can I set the V-REF and PFD ? In mach3 what can I set the motor tuning ?...
I just received my stepper motor from MPJA. (PK266-01A) Now i'm stuck, I know we need to use 4 of the 6 wires, I looked at the connection...
Ok I did a design and now when I generate the g-code it sends the printer all around, its start in the bottom the goes to the top and starts...
I'm trying to put tab on this part and it don't want to place them. I made the outside cut but no tabs. Can someone help me out i've included...
Ok been reading that everyone changes thier stepper motor for axis Y-Z for bigger. My question is should I be looking at the holding Torque...
Which stepper motor to get is the question (For the y axis) I've been looking at the following Nema23.......
Did something today and I lost all hope... now motor skips step, do not move back and forth...lol Can someone point me in the right direction on...
Hi all My question is trying to cut a 1/8" foam and bit diameter set to 1/16" my bit is set flush with the table top. When cutting the bit...
K used the orbit tool to move drawing arond, but now I can't seem to put it back in the correct angle. Meaning when looking at the picture its...
Separate names with a comma.
