Sign Up and take a look around. There are so many awesome new features.
have fun sharing our RC adventures!
yes, if you would like, you may also email at campbelldoug2004@yahoo.com
thanks!
I have a complete assembled MK III for sale. The last time I used it was a year ago and it worked fine. Just have not had any time to do anything...
I'm back after more tests. Frequent things that still happen off and on. It's unpredictable. Finish cutting a small file. 2 pieces in the file....
Yes, it sounds like this is what's happening to me also. I really only get these failures from larger cut files, after a period of cutting time...
Here is the pic of the foam test cut. I drew in ink on the foam and enhanced the contrast so its more visible. Seems like all the parts cut...
I just ran a test piece of pink foam. It was single pass at slower rpm. Hooked up the new USB cord. The parts in themselves were accurate except...
Thanks for info on multi-pass. Maybe I need to go with that instead. I does seem like the bit is at ease with my ipm at one pass on this lite ply,...
Thanks Mark. I will do all of that and let you know. - Doug
Here is the latest. I'm attaching some pix and files to see if anyone sees an issue I did wrong. Cutting 1/8 lite ply, very soft and light. Found...
OK, this is nuts. I ran the same cut file again today as yesterday's disaster. No changes to anything. Cut perfectly. Maybe I was tilting my head...
Thanks for the info. I just tried running a cut file yesterday and it was totally whacked. Started out fine, then after a few seconds the x-axis...
Naw, this stuff is all happening with the vac off and the tool motor off. Just jogging. Rebooting alot seems to clear it, for awhile............
Well I sure don't know why, but the machine again jogs perfectly. I was getting some quirky noises from the z motor when it was not stopping. I...
Thanks for the info dhc8guru and thunder hawk. Yes, this issue comes and goes. Sounds like I had a similar thing happen dhc8guru. I ran about 6...
went to the machine turned on and jogged. x axis working fine now. z axis still doing the "no stopping thing" i'll check any interference Kroko....
Maybe it's connections, I'll check them. But working fine one moment then acting up on a bad connection? I'll make sure it's all connected then...
Hi I had just finished up with cutting some 1/32 ply and the machine was a little off for the last cut so I just got done calibrating. I notice...
Followed your guidelines for speed and feed and got a nice cut on 9mm epp of an f22. Used pink ff as a backer. Thanks for your trial and error for...
Separate names with a comma.
