1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

#35 is completed

Discussion in 'General Phlatprinter 3 Chat' started by Darwin, Dec 26, 2010.

  1. Darwin

    Darwin Member

    Offline
    Messages:
    44
    Trophy Points:
    6
    Hi, Guys:

    Just an extremely short note to announce that Phlatprinter /// #35 is assembled and operating.

    All three axis move. The X-rollers make a heck of a noise when doing fine movement. Only thing I've noted so far.

    Will move toward making cuts tomorrow.

    Regards,

    Darwin
     
    Darwin, Dec 26, 2010
    #1
  2. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Congratulations Darwin! :D
     
    kram242, Dec 27, 2010
    #2
  3. Darwin

    Darwin Member

    Offline
    Messages:
    44
    Trophy Points:
    6
    And now I have successfully cut the table file. :)
     
    Darwin, Dec 27, 2010
    #3
  4. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    :mrgreen: Way to go! :mrgreen:
    Its a cool feeling to see something you built come to life isn't it :)
    Just remember the spindle speeds with the 1/8 stock bit needs to stay at 50 ipm feed rate or below so that it doesn't push through the foam.
    Have fun Darwin great job
    Mark and Trish
     
    kram242, Dec 28, 2010
    #4
  5. ToxicToast

    ToxicToast Down in the weeds. Staff Member

    Offline
    Messages:
    483
    Trophy Points:
    18
    Location:
    Roseville, CA
    Congrats! It is a wonderful feeling! Once its dialed in tightly you'll be churning out airframes!
     
    ToxicToast, Dec 28, 2010
    #5

Share This Page