Hi there,

I have recently got my Phlatprinter up and running. Cutting 1/4" stuff perfectly. Now I want to cut at 13/16" now the problem I encountered is whenever I use the properties dropdown box, besides it being blank if I change anything it will not generate g-code.

I am running Ubuntu Linux 8.04 with Sketchup 7 and phlatscript 0.918 if that helps anyone.

Yes the setting screen in the phlatscript come up blank but I use the cheat sheet to know which boxes to fill in. I have tried changing these settings before I even start designing anything in Sketchup.

Just very strange, so does anyone have any ideas.... Other than that I am printing away on 1/4" stuff happily. ;-)

 

The empty parameters dialog under Wine is causing more problems that it appears. Check out this post I made concerning linux compatibility http://www.phlatforum.com/viewtopic.php?f=100&t=300&start=75#p6658.

 

Cool thanks I will have a look now I managed to totally bugger my sketchup install so I will be redoing it. Will try that as well while I am about it. ;-)