1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Autodesk 123D

Discussion in 'General Talk Forum' started by lovebugjunkie, May 29, 2011.

  1. lovebugjunkie

    lovebugjunkie New Member

    Offline
    Messages:
    57
    Trophy Points:
    0
    Found this from a post on another forum. Only been playing with it for an hour or two. I have found it much easier to use than most inexpensive 3D programs I have tried. It's Free.

    http://www.123dapp.com/content
     
    lovebugjunkie, May 29, 2011
    #1
  2. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Very cool lovebugjunkie :good:
    Thank you
    Mark and Trish
     
    kram242, May 29, 2011
    #2
  3. rcav8r

    rcav8r Moderator Staff Member

    Offline
    Messages:
    1,193
    Trophy Points:
    38
    Pretty cool. I'll need to download and try. Being it's from Autodesk, wonder if it's like inventor? A few years back I helped some engineering guys with Inventor. Took a while to get what it wanted you to do, but once you understood their way of thinking, it was rather easy.
     
    rcav8r, May 29, 2011
    #3

Share This Page