1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Circles again:

Discussion in 'General Phlatprinter 3 Chat' started by Keckhaus, Nov 14, 2012.

  1. Keckhaus

    Keckhaus New Member

    Offline
    Messages:
    26
    Trophy Points:
    1
    I have made sure that the X drive pully is tight and not moving, and I have set the backlash to 0.04, and I still have a little hiccup, when the bit gets to the top of the circle the machine bumps almost like it wants to change position, and it does it at the bottom of the circle. It could be better explained that the bit moves like it is being jogged.

    Any thoughts are appreiated,

    Ken
     
  2. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    .040" is a lot to have set in backlash. It's jerking because it's moving that much as set by your backlash.
     

Share This Page