1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Easy-cnc driver board manual

Discussion in 'Easy CNC Driver Card' started by kram242, Jun 5, 2009.

  1. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Here is the manual for the popular 3 axis easy-cnc driver board
    Attached files Manual3Axis(NEW).pdf (242.1 KB)Â
     
    kram242, Jun 5, 2009
    #1
  2. Crash

    Crash Moderator Staff Member

    Offline
    Messages:
    469
    Trophy Points:
    18
    Location:
    Waco, Texas, USA
    Thanks for posting this, Mark. All this time that I've been using this card, I've never even seen this. Now I know what points to contact to check out my voltage going to each phase.
     
    Crash, Jun 5, 2009
    #2
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    No problem Mike :)
    I thought it was on here then when you asked then I went to look for it and it was no where to be found!
    Hope it helps
    Mark
     
    kram242, Jun 8, 2009
    #3

Share This Page