1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

error while starting file stream: command #70 too long (51 > 50 )

Discussion in 'SketchUcam Help' started by Annemiek Nieboer, Sep 11, 2014.

  1. Annemiek Nieboer

    Annemiek Nieboer New Member

    Offline
    Messages:
    1
    Trophy Points:
    1
    error while starting file stream: command #70 too long (51 > 50 ) (Retract feed rate NOT limited to plunge feed rate)


    anyone an idea what this means?

    Just starting to use sketchucam. (working from mac and su 2014)
     
    Annemiek Nieboer, Sep 11, 2014
    #1
  2. swarfer

    swarfer Moderator Staff Member

    Offline
    Messages:
    808
    Trophy Points:
    28
    Location:
    Grahamstown, South Africa
    when exactly do you see this message?
    and, post the file that generates it.
    what version of sketchup?
    what version of sketchucam? if you havn't got 1.2, install it now, restart sketchup, and try again.
     
    swarfer, Sep 12, 2014
    #2
  3. swarfer

    swarfer Moderator Staff Member

    Offline
    Messages:
    808
    Trophy Points:
    28
    Location:
    Grahamstown, South Africa
    looks like you may be using GRBL with the universal gcode sender, which has a line length limit.
    see here http://www.shapeoko.com/forum/viewtopic.php?f=3&t=3545 for a solution
     
    swarfer, Sep 12, 2014
    #3

Share This Page