1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Mach 3 on MKIII machine

Discussion in 'Troubleshooting and Build Support' started by Keckhaus, Jul 8, 2012.

  1. Keckhaus

    Keckhaus New Member

    Offline
    Messages:
    26
    Trophy Points:
    1
    Hey guyz, I am having difficult time gett the Z axis to califbrate using Mach 3. I am sure that I have followed Crashes video correctly. The errror statemenst shows up start up, stating that one of the motors is at 250000. However when I go to calibrate it,itwill only drop down 0.05 and the will not go back up>

    I have double chcked that I have all of the ducks in a row. Sure would apreciate some help..


    Ken
     
  2. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    When you calibrate, Ken, the axis does not return. To return you have to jog it. Can you jog the z axis up and down?
     
  3. stonjohn4

    stonjohn4 New Member

    Offline
    Messages:
    1
    Trophy Points:
    0
    Hey Guys, I noticed my stepper motors are running very hot. How do I check and adjust the voltage on the mechatronics driver board? Thanks!!!!! :twitch:

    Eric
     
  4. rcav8r

    rcav8r Moderator Staff Member

    Offline
    Messages:
    1,193
    Trophy Points:
    38

Share This Page