1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

MICRO KnightOWL

Discussion in 'Strange Aircraft' started by kram242, Nov 25, 2009.

  1. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Here is the Micro KnightOWL

    3mm Depron
    All power parts are from the micro flying truck, but I think you could use any cheap micro heli parts to make this work


    Have fun! :D

    Attached files MicroKnightOWL_3mm.cnc (46.7 KB)Â NightOwlMICRO_3mm.skp (4.2 MB)Â [​IMG]
     
    kram242, Nov 25, 2009
    #1
  2. gasmasher

    gasmasher New Member

    Offline
    Messages:
    402
    Trophy Points:
    0
    Location:
    Atlanta, GA
    I really like this model Mark. I just watched the build video in the other thread and was really surprised how much control you had in in the space of the phlatlab. I think this will be the first thing I cut out of depron.
     
    gasmasher, Nov 28, 2009
    #2
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Cool Tim :) I will have to tell you that the depth of the center line cuts are too deep, not sure why they came out so deep. But you can over come this by allowing a good 3/32 to 1/18 down from the material before you start your cut.
    Looking forward to seeing how this turns out for you Tim
    Mark
     
    kram242, Nov 28, 2009
    #3

Share This Page