1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Need a little help.

Discussion in 'Trouble Shooting - Support - Help Section' started by ewo, Apr 8, 2010.

  1. ewo

    ewo Moderator Staff Member

    Offline
    Messages:
    701
    Trophy Points:
    18
    Location:
    Indiana
    When i built my MK1 there were videos online that showed every step of the build !
    I had absolutely no problems with the build ! or the mach setup

    But now with the videos gone, i have no way of setting my machine back up with the original settings for the motor tuning since i didnt write anythin down, I figured the videos would always be there for reference if i ever needed to reset my machine.

    My question is simply , Is there anyone out there with a stock MK1 that still has the recommended settings for the MK1 motor tuning?

    My machine is completely stock.
    I think i have the x axis way out of kilter :shock:


    Thanks for any help
     
    ewo, Apr 8, 2010
    #1
  2. kyyu

    kyyu Active Member

    Offline
    Messages:
    1,183
    Trophy Points:
    36
    Location:
    Maryland
    ewo, actually I downloaded all the videos. I got lucky and was able to find them on a loose hard drive. But those videos are huge. Just the electronics setup video is like 3gig. :shock: But I copied down the initial settings for you:

    X
    1000, 20, 20

    y
    13953.48837, 20, 20

    z
    30000, 20, 20
     
    kyyu, Apr 9, 2010
    #2
  3. ewo

    ewo Moderator Staff Member

    Offline
    Messages:
    701
    Trophy Points:
    18
    Location:
    Indiana
    Thank you sir ! Now i have the original starting settings i can try to tweek my machine back into the machine it was before something went wrong :(

    Thanks again for your help with this
     
    ewo, Apr 10, 2010
    #3

Share This Page