1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Newbie

Discussion in 'General Talk Forum' started by truehybridx, Apr 25, 2012.

  1. truehybridx

    truehybridx New Member

    Offline
    Messages:
    5
    Trophy Points:
    1
    Hi All..

    Came over here from a link on LinuxCNC. Was wondering whats the latest version of this plugin? and if its seeing active development?
     
    truehybridx, Apr 25, 2012
    #1
  2. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    Latest version is here:
    viewtopic.php?f=98&t=2

    It's been a while since any updates have been made. If you would like to pitch in I'm sure you would be welcomed. :D
     
    3DMON, Apr 25, 2012
    #2
  3. truehybridx

    truehybridx New Member

    Offline
    Messages:
    5
    Trophy Points:
    1
    If i knew more of ruby than just how to say hello id look into helping -_-, i don't understand enough about sketchup's internals to be any good
     
    truehybridx, Apr 27, 2012
    #3

Share This Page