1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Speed Control? Roto?

Discussion in 'General Talk Forum' started by MarxNarx, Mar 15, 2009.

  1. MarxNarx

    MarxNarx New Member

    Offline
    Messages:
    2
    Trophy Points:
    0
    Has anybody tried using a Roto-Zip, instead of the Dremel?

    Is there any way to incorporate a programmable speed control for lower RPMs, for cutting plastics? :?:

    I've been reading this stuff for a week, but haven't seen this mentioned. I'm hooked, and I'm going to have to build one. :D :lol:
     
  2. rjarois

    rjarois Moderator Staff Member

    Offline
    Messages:
    1,263
    Trophy Points:
    36
    Location:
    royal oak, michigan
    MarxNarx, i was looking at them before i did my dremel nose mod....the ones i seen are very big, and will not even be close to fitting under ther....after i centered my dremel to the table slot, ther is like a 3/32 clearance between tool and the main feed roller. randy.
     

Share This Page