1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Tab depths gone goofy

Discussion in 'SketchUcam Help' started by Jnida63, Mar 1, 2009.

  1. Jnida63

    Jnida63 Member

    Offline
    Messages:
    749
    Trophy Points:
    18
    My Z axis is working fine but none of my tabs are going %50 thru the material anymore and my centerline and fold cuts aren't getting cut either.

    Anyone had this problem before?
     
    Jnida63, Mar 1, 2009
    #1
  2. Anonymous

    Anonymous New Member

    Offline
    Messages:
    1,280
    Trophy Points:
    0
    Maybe your bit is slightly loose and has slipped down. I setup a z-axis home switch so I know the router starts in the same place each time, but if the bit slips, zero is not zero anymore.
     
    Anonymous, Mar 1, 2009
    #2
  3. Jnida63

    Jnida63 Member

    Offline
    Messages:
    749
    Trophy Points:
    18
    Nope, it was a bug in the script. blew out the folder and re-installed and it's fine now
     
    Jnida63, Mar 1, 2009
    #3

Share This Page