I was doing some testing of 3D cutting One time I left marked to mult step The plugin failed, even clearing the mult step, I could not make cuts in 3D Installed over the new beta version, still the problem continued. the only way to make cutting in 3D, was to delete the files and reinstall after clean install, everything went back to normal, 3D cut works perfectly This was a bug? There is forecast to make cuts in mult step 3D?
I have just tested my install of the beta3, and it works just fine. You must remember to restart Sketchup after the install. However, if you have a flat drawing as for normal Gcode generation, and tick '3D', the plugin will fail. 3D mode only works on an actual 3D object, with its base on the XY plane, and no cutlines must be applied. Please note that the 3D cutting function is very rough and you should preview your Gcode in something like OpenSCAM before cutting actual material. A 3D cut can take hours.
I understand the difficulties and the challenge of putting new features There is forecast to implement mult step in 3D? hugs
multipass in 3D is already there! Note that the safe area must be at X0 Y0 The 3D object must be at least 1 bit diameter from the bottom left corner of the safe area. See attached example display and the file that generated it. In a few hours 1.1e-beta4 will be available, please install it as it will contain a small bug fix in the 3D generator.
Thank you for listening I would like to make 3D gcode with mult step of Figure But I can only generate 3D without mult step
Eureka! I discovered my mistake as always cut 1/4 plates "(6.35 mm) forgot to mark the correct thickness in the model Increased the number of details to force the test There was an error with the tool back into the material Attached, the Skp and gcode Thank you for listening and detachment.
you need to move the part away from the origin. I moved it 5mm up and right and the code came out alright. changing to 25% stepover made it even better. here is a rendering from OpenSCAM for the code I generated.
While generating the gcode correctly, this was not the result I wanted The square base, I did not want to cut, just cut the part profile I solved the problem by placing the settings a greater height than the model The piece has 30mm, 31mm configured with this solved partly because I needed take an extra step on the material (waste of time). put the gcode exited properly. Many pieces already have the lateriais the material in the correct measure Just need to cut the top result: Despite having to take an extra step I am very pleased with the result If encounter other difficulties, I report I hope this topic can help someone and show 3D capability congratulation, this wonderful plugin Thank you very much. hugs
