Sign Up and take a look around. There are so many awesome new features.
have fun sharing our RC adventures!
It was a year long bout with cancer that took him on October 29, 2017. All of us here in the beginning remember him as a charismatic personality...
I just had a couple PhlatLab links land in my email box so I figured I'd jump over and see how things are going on the forum. Guess I missed the...
It was a one off setup that didn't get re-assembled correctly mechanically so it didn't work quite right. I spotted the Z screw rod out of its...
Sorry no updates. Life happened again and I got busy and the EP DLG project was pushed onto the back burner. On a good note necessity dictated I...
Nice work Shaun. Is the unit in use? I got slammed for offering one on Craigslist because I'm not an approved medical service provider. Jerks,,,...
Finally got the adjustable holder built for the vapor chamber, and did the vaporing. The build starts tomorrow.[ATTACH] [ATTACH]
Give Cubify Design a try. Very similar to SW and only $199
Good read on the boomprop, thx. Fabricating the vapor tray today. Pics tomorrow
Thanks, I'm happy with them also. Getting that wall thickness to .8mm was the key. The final weight after 99% of the cleanup is 1.865 oz. or 53...
I tried Cura a little but I couldn't get passed the curve. Just off the printer and weighing 3.25 oz before support removal. And there is a lot...
Printing the final revision is in process. I'll take pictures for sure.
Thank you both for the compliments. I had to switch back to Solidworks from SU because as my drawings got more complicated SU would constantly...
Not yet. Kind of waiting till it's all done and I can do a semi good job at presenting it. Problem is I'm so hit and miss with time. I did dowel...
Go for S3d it's well worth the features. Plus it prints sooooooo nice. Support just falls off, I could rave for an hour on this software. Here's a...
Separate names with a comma.