Sign Up and take a look around. There are so many awesome new features.
have fun sharing our RC adventures!
Thanks TT. I've liked the Tiger MT motors thus far. They come will long leads which is nice when you want to route them back to the center of...
Thanks. Each 16mm arm tube is clamped by two boom block pairs inside the central frame. When the boom blocks are tightened the tubes don't...
Hey guys. Just wanted to post the hexacopter project I just finished. The specs are below and I am happily cutting G10 FR4 parts out as needed....
Yoram, Sorry about the delay getting back to you. I just got back from vacation and saw your post. My E-Stop just disconnects the 110V AC to my...
Thanks Andrej! Updating the firmware and reloading the usb drivers got me up and working again. Thanks everyone for the help. Ben
dugd1013 & thunderhawk, Thanks to both of you for the troubleshooting ideas. I've checked my connections and reimported the license in the...
Hey guys. I tried to power up the MK3 today and wasn't able to get any steppers to respond or have the usbcnc software have active "colored"...
I was shopping at Costco today and picked up a shelving unit to replace my folding table for a MKIII stand. It went together quickly and is a...
The new aluminum pulley arrived this Thursday from sdp-si. I was able to get it installed on the stepper yesterday. If anyone buys these as a...
Dugd, Thanks for the confirmation on the part number. That's the exact one I picked so that is good. Should be delivered tomorrow so I'll try...
Ken, Fantastic. Thanks for posting these.
Thanks Gefahren. I went and counted the grooves on the P3 stepper pulley and got 18. Looking at the timing pulley on the Phlatstore (if it is...
Hey guys. I played around with the belt tension on my axis more today and couldn't quite find a tension that prevented skipping. It seems worse...
Separate names with a comma.