1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Recent Content by jadudm

  1. jadudm
    Post

    Green LED went away on Phlatprinter3

    OK. 1. The board takes 5V external power, blinks "hello", and shows up on my VM. I did not try a cut at this time, but I suspect "all is good."...
    Post by: jadudm, Feb 15, 2012 in forum: Planet CNC USB Controller Card
  2. jadudm
    Post

    Green LED went away on Phlatprinter3

    The board comes to life on external 5V power... and...
    Post by: jadudm, Feb 15, 2012 in forum: Planet CNC USB Controller Card
  3. jadudm
    Post

    Green LED went away on Phlatprinter3

    Hi Mark, Many thanks. However, we had a functional foam cutter for the past two months. We've been using it consistently 2-3 times per week....
    Post by: jadudm, Feb 15, 2012 in forum: Planet CNC USB Controller Card
  4. jadudm
    Thread

    Green LED went away on Phlatprinter3

    Hi all, We've been cutting happily for some time with our PhP3. Last night, the green light on the USB board went out. Our setup is: * Mac...
    Thread by: jadudm, Feb 15, 2012, 6 replies, in forum: Planet CNC USB Controller Card
  5. jadudm
    Thread

    What driver do we use for the USB Controller?

    Hi all, We're a bit stumped. We have an old XP machine that is not networked (for its own health and safety). We've installed .NET, DirectX, and...
    Thread by: jadudm, Sep 8, 2011, 1 replies, in forum: Planet - CNC USB Software