1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Control surface bevel cuts W/fold tool 20,40,60,80

Discussion in 'Sketchup Tutorials' started by Evil-Tunes, May 12, 2009.

  1. Evil-Tunes

    Evil-Tunes Moderator Staff Member

    Offline
    Messages:
    659
    Trophy Points:
    16
    Location:
    Southern N.J.
    Here is A Tutorial doing bevel cuts with the Fold Tool.
    Mostly for controll surfaces but can be used any where.
    You can do this on leading edges also.



    Cheers

    E-T
     
    Evil-Tunes, May 12, 2009
    #1
  2. 66tbird

    66tbird Moderator Staff Member

    Offline
    Messages:
    431
    Trophy Points:
    18
    Location:
    Deserts of Arizona
    Nice, clean and simple, thank you :D
     
    66tbird, May 12, 2009
    #2
  3. dz1sfb

    dz1sfb Member

    Offline
    Messages:
    116
    Trophy Points:
    18
    Very nice technique ET!

    I am having a problem being able to type in the depth value. I pick up the line and the defualt 50 shows up in the box, but am not able to overtype, and any kind of type. Any clue what I am forgetting. You mentioned something about the W key, but I could not quite make it out.

    Thanks,
    Ken :)
     
    dz1sfb, Jun 17, 2009
    #3
  4. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    Hey Ken,
    Try using the numbers above the letters instead of the numbers on the keypad. For some reason the numbers on the keypad doesnt change anything. Also the "W" key is to toggle between wide or short fold lines.
     
    3DMON, Jun 17, 2009
    #4
  5. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Very well done Glen! Thank you for posting
    Mark
     
    kram242, Jun 17, 2009
    #5
  6. dz1sfb

    dz1sfb Member

    Offline
    Messages:
    116
    Trophy Points:
    18
    Thanks 3DMON! worked perfectly.

    Thank you Evil-Tunes for a great tip.

    Ken :)
     
    dz1sfb, Jun 17, 2009
    #6
  7. AnyAirRc

    AnyAirRc Moderator

    Offline
    Messages:
    227
    Trophy Points:
    0
    Man ET that was a great tut! I never have used the construction lines but they rule! Thanks again I have been doing it the harder way for a long time now.
     
    AnyAirRc, Jun 19, 2009
    #7
  8. Evil-Tunes

    Evil-Tunes Moderator Staff Member

    Offline
    Messages:
    659
    Trophy Points:
    16
    Location:
    Southern N.J.
    Thanks

    They get in the way some times but are easy to delete. I use the protractor ones also. Very handy.


    Cheers
    E-T
     
    Evil-Tunes, Jun 19, 2009
    #8

Share This Page