1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Lost Calibration - Mach3

Discussion in 'Trouble Shooting - Support - Help Section' started by Hankado, Dec 6, 2009.

  1. Hankado

    Hankado New Member

    Offline
    Messages:
    17
    Trophy Points:
    1
    I turned on my system today to cut out some plans and low an behold after a few min i realized the parts were way too small. I had to recalibrate all 3 axis again. This happened to me before but i just thought i did not save my configuration. Now its happening to me again.

    Do i need to calibrate they system everytime i turn it on?

    Hank.
     
    Hankado, Dec 6, 2009
    #1
  2. Jnida63

    Jnida63 Member

    Offline
    Messages:
    749
    Trophy Points:
    18
    No, you shouldn't have too, although I just ran into the same problem, hope i'm not missing steps again.
     
    Jnida63, Dec 6, 2009
    #2

Share This Page