1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Mod Parameters after completed

Discussion in 'SketchUcam Help' started by jwalter007, Jan 6, 2013.

  1. jwalter007

    jwalter007 New Member

    Offline
    Messages:
    8
    Trophy Points:
    1
    If I have created my drawing & made the cut lines can I then modify the material thickness & bit size then gen gcode or does the parameters need to be set before creating cut lines?
     
    jwalter007, Jan 6, 2013
    #1
  2. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Hi jwalter007,
    At this point in SketchUcam you have to do all the parameters before assigning the cut line. We had hoped it would be able to be changed after, but the programmers that helped to work on the project told us it was a monumental task to make that happen. Still maybe some day we can see this happen :good:
    Mark and Trish
     
    kram242, Jan 6, 2013
    #2

Share This Page