1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Outside Cut Issue

Discussion in 'SketchUcam Help' started by bhiggin, Jul 22, 2011.

  1. bhiggin

    bhiggin New Member

    Offline
    Messages:
    1
    Trophy Points:
    0
    Does anyone have any helpful tips as to why my outside cut isn't working (see attached)?

    Thanks,

    Brad

    I'm running SketchUCAM with Sketchup 8 Attached files Front-End Template.skp (133.4 KB)Â
     
    bhiggin, Jul 22, 2011
    #1
  2. rcav8r

    rcav8r Moderator Staff Member

    Offline
    Messages:
    1,193
    Trophy Points:
    38
    Sorry, can't view the file. I'm running SU 7. If no one responds ( some one probably will) please save down.
     
    rcav8r, Jul 22, 2011
    #2
  3. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    Sorry, can't help you. Your drawing was saved in SU 8 and I have SU 7.
     
    TigerPilot, Jul 22, 2011
    #3
  4. xtremeRCpilot

    xtremeRCpilot Member

    Offline
    Messages:
    736
    Trophy Points:
    16
    Location:
    Cleveland, Ohio
    Hi Brad, All fixed, you had 15 broken lines!Not sure why yet but if you drew this in another program and imported it that is usually the culprit! :p
    Install the below plug in for future use, it is a life saver before rendering your G code!
    Thanks
    John Attached files Front-End Template Repaired.skp (127.9 KB)Â RepairBL and Phlatten v1.1.rb (3.8 KB)Â
     
    xtremeRCpilot, Jul 24, 2011
    #4

Share This Page