1. Dismiss Notice

  2. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  3. Dismiss Notice

  4. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

Welcome to The Phlatforum PhlatPrinter III

PhlatPrinter Wannabe Hybrid

Discussion in 'Trouble Shooting - Support - Help Section' started by giuseppi, Oct 30, 2014.

Page 2 of 2
  1. BobAd

    BobAd New Member

    Offline
    Messages:
    6
    Trophy Points:
    1
    Location:
    Vero Beach, Florida
    If you want to use the full sheet of material add about 2 inches to each end. But leave the material size the same in gcode page setup. use a glue gun to hold the tabs on each end I use 2" x 4" 2 at each end.
     
    BobAd, Dec 20, 2014
    #26
Page 2 of 2

Share This Page