1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Santa wreath

Discussion in 'Christmas' started by nstaller, Dec 14, 2011.

  1. nstaller

    nstaller Member

    Offline
    Messages:
    52
    Trophy Points:
    6
    Here's one I worked up. I originally built it for my parents a few years ago. The one in the pic is the original, I cut one out and it looks good just havent had the time to paint it yet. Enjoy

    Attached files santawreath.skp (1.7 MB)Â [​IMG]
     
    nstaller, Dec 14, 2011
    #1
  2. nicolestrovich548

    nicolestrovich548 New Member

    Offline
    Messages:
    1
    Trophy Points:
    0
    I really want to make something like that for our door but I am thinking of using cork board sheets as my medium.
     
    nicolestrovich548, Nov 27, 2012
    #2
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    I did see that one of the guys was cutting cork board with his Phlatprinter. Not sure how well it cut but I suppose with the right bit anything is possible! :)
    Good luck with the project nicolestrovich548 let us know how you make out.
    Mark and Trish
     
    kram242, Nov 27, 2012
    #3

Share This Page