1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Thunder Hawks dual vacuum port mod.

Discussion in 'Phlatformer MODIFICATIONS' started by Broomstick, Oct 7, 2010.

  1. Broomstick

    Broomstick New Member

    Offline
    Messages:
    11
    Trophy Points:
    0
    George ( aka Thunder Hawk ) added the dual vacuum ports so we could do
    pulls with the shop vacuum attached on either side, just in case we had to do
    pulls at the table on the other side of the studio. Space is limited.
    [​IMG]

    Notice the vacuum port covers. More about those below. :cool:
    [​IMG]

    [​IMG]

    [​IMG]

    The port covers are "Shepherd Hardware Products" Model #9364
    caster cups for wooden floors. They are 2-3/8" I.D with a cup depth of 3/8".
    You can get them at Home Depot.
    [​IMG]

    Hope this helps.
    Broomstick.
     
    Broomstick, Oct 7, 2010
    #1

Share This Page